FrameWIN Subframe Calculation


On the screen there will be the pictures of the calculated Chassis Frame Profile and the Subframe Profile mounted on top of it. On the left side picture, beams are mounted in each other flexibly. On the right side picture; beams are mounted with shear resisting plates, first so that the mounting is shear resisting, but the plates are not calculated in strength calculation (mounting with many separately plates) and then so that the plate is also calculated in the strength calculation as a part of the beams ( in this case the plate must be a continuous plate ).

Below the beams You will see the calculation results for the combined beam; on the left side with Flexible mounting and on the right side with mounting with shear resisting plates.

Second moment of area Ix ( cm4 ) Section modulus Wx ( cm3 )

Stress (on the subframe) s ( N/mm2 )

Stress (on the chassis frame) s ( N/mm2 )

Safety Factor Static n stat

Safety Factor Dynamic n dyn

In New FrameWIN 2000  version You have the possibility to build subframe by combining many (10) different profiles together.

Program is available in following Languages: TrailerWIN, CraneWIN, FrameWIN

Danish, Dutch, English, Finnish, French, German, Italian, Norwegian, Spanish, Swedish

trailerwin, cranewin cornerwin framewin brakewin buswin fridgewin axle loadings weight calculations truck bodies  trailers trailer 
bodies draw bar trailers cranes truck mounted cranes allmi cab tilts truck chassis makes truck chassis models trucks commercial 
vehicles commercial vehicle software stability calculations turning circles payload calculations load curves diminishing loads 
axle overloads crane tilt angle crane stability tilting line stabalizers bus layout coach layout bus coaches route planning
 subframes dynamic calculations moment safety factors construction and use c and u eu regulations tankers tipper curtainsides hook 
bodies beavertail car transporters refrigerated vehicles cv drawings lines industries technical calculations